K&NCold Air Intake System: High-Flow Air Filter, Increase Performance & Towing: Compatible with 2016-2024 JEEP/DODGE: Durango, Grand Cherokee, Grand Cherokee WK, 77-1572KS

So there are a lot of reviews for the Grand Cherokee but not for the Dodge Durango, this is a review for the Durango. So we own a 2017 Durango SXT, one of the main issues we had was when trying to pass someone on a 2 lane highway it would sound like you were almost at redline, but would very slowly pick up speed. Not to mention the engine lag before we even got to that point. Bought this kit on chance because there were no reviews for the Durango. So as far as quality goes, all is well. All seems durable and should last for years. Fitment was a bit tricky. Disassembling the old intake I ran into issues with the breather elbow. Easiest way i found was to take a small jewlers screwdriver (flathead) and pry it in between the pvc elbow and the hose and very slowly and carefully pry and work your way all the way around. If you take your time and shouldnt break the elbow. Once old intake was off, the next small issue I ran into was trying to connect all the fittings for the main pipe. Not a deal breaker by any means but I felt like K&N could have made it a bit longer. I get its meant to fit 2 different vehicles, but it was a bit of a squeeze to get it all connected comfortably and not sitting in the edges. Many other users also claim to have issues with the AC lines, went down to the local lawn and garden and found the rubber hosing for underground sprinklers similar to the diameter of the AC lines, split it, and wrapped it over the AC line to prevent friction and rubbing. Last issue was reinstalling the Mass Airflow Sensor. It is a delicate little beast, and the position of the new grommet maxes out the cables. It is a very snug stretch. When I put it in the first time it fell out during a test run. I liked my finger and wet the Grommet, make sure you push it all the way in. It is a bit of a struggle to get it in all the way. Feels like its maxed out...but there is more travel room. As far as gas milage goes, other reviews seem to hit it on the head, pretty much 2-3 average MPG. That was just an added bonus for us, it really picks up and goes now. Throttle response has vastly improved, you hit the gas and it goes. Fixed ALOT of the lag and slow acceleration. Only real drawback is the sound. It makes it sound amazing and really gutty, but it can be slightly annoying at higher RPMs on the highway. You will find yourself letting off the gas to allow it to downshift just to stop the resonating coming from the engine bay. I can see where it could be too loud for some people and why some hate the noise. All in all, it sounds like a beast, picks up and goes, and improved gas milage. Small fitment issues but nothing crazy and no real deal breakers. I strongly recommend to all V6 Durango owners***Update***Had it for over a year now, no issues with the tight reach for the MAF Sensor. Must have for all V6 Durango owners. Well worth the price.

Easy install and works great

I put this into my 2018 Dodge Durango GT. It was a pretty simple install. Like others I had trouble getting the elbow off of the crank case vent tube. I actually destroyed the elbow in the process. I was also not so happy that the aluminum intake tube sat pretty much on the AC lines. The instructions say you should relocate the AC lines, but they do not say how to do that. I just rotated the tube to get it off the AC lines as much as I could and then put a length of nylon hose around the AC line to prevent any abrading that might occur. Once it was installed it and I took my car for a drive the first thing I noticed was that the engine sounded pretty much just like it did before I installed the CAI. Then I stepped on the accelerator and it turned my V-6 into a throaty V-8! Secondly, the power was noticeable. At least I want to say it was noticeable. If you are pushing 300 ponies, I don't think you are going to notice another 11 all that much. Either way, it did not decrease my horsepower. It would be impossible to decrease the horsepower, if you look at the factory intake it is rife with plenums, chambers, twists, turns, and restrictions. Which is another thing that this CAI does is that it cleans up the engine compartment a lot. The factory intake is enormous. The filter that comes with this CAI is the largest that I have ever encountered. It definitely opens up the intake of my Durango. I love the K&N CAI. It sounds great. It looks great. And it gives me all the power my Durango has to offer.

Have used K&N filters and intake kits in the past and currently have them on my other cars, easy 30 min install, quality parts and directions were good as usual. Can't even tell you have it at idle, nice sound at part throttle/highway, but quite loud at full open throttle, so just a heads up, just seems that the way the engine bay is very open on this model and the redesign of the intake manifold from the 2012-2015 models you get a lot more cabin noise from this intake (Had one on a 2015 and cabin noise was less as it was a much longer tube), if you were wondering why the factory intake has so many baffles and chambers, there you go.Did get a bit better on mileage, about 2mpg highway, but the same city driving. Engine has better midrange power, but otherwise it depends on driving style.Also: the intake tube will rub the A/C line, the line can be pushed downward slightly, but there is not a lot of adjustment, I cut a piece of rubber hose and covered the A/C line, just in case.

Great product and fulfills what I was looking for. I’ve installed 4 K&N CAIs on various vehicles and this one on my 2017 Durango V6 had the biggest sound improvement I’ve seen by a long shot, this thing sounds great, overly impressed here. MPG is still to be determined, but as long as it doesn’t decrease, I will be happy.Install was easy and straightforward. A lot of reviews on here will say it comes in contact with their AC line. This is accurate yes, but also 100% avoidable. If you simply adjust the tube into the rubber hose fittings it comes with to be slightly “angled” before righting the clamps, you can get a good half inch away from the AC line. I also took the filter housing and bent it just slightly to allow even more room. I have zero worry or issue the intake tube will come in contact with the AC line. With that said, there is so much room under the hood where this thing goes, it’s kind of embarrassing K&N didn’t manufacture it to make this a non issue from the getgo, and that’s why it gets 1 star docked from it.Overall I’m pleased with another K&N CAI and I will continue to put them in any vehicle I own.

Pretty simple to install, takes a little time, definitely gives you a little bit of power and a little bit of fuel efficiency and a lot of noise. The noise is 70% wanted/throaty, 30% drone from the cabin.The great news is at low gas pedal demand, you get zero additional noise or drone.