cciyu 6 Pack T4/T4.2 Neo Wedge 2835 SMD LED Bulb A/C Lights (red)

I installed these into the climate control lights on my 2003 toyota tacoma. They are super bright and easy to install. No problems so far. Good replacement for burnt out lights.

Installed these for my 05 xB to upgrade the HVAC lights. Installation requires some modification to the fitment and connection. Had to widen the hole to make the bigger bulb fit and solder the connection due to placement of contact on bulb. Brightness was hindered by the dash design. But overall good quality bulb for the price. Definitely makes the car more modern.

I purchased the single LED, T4 Neo Wedge 6 pack to replace two bulbs in a Toyota climate control panel. I chose the LEDs so I would never have to replace them again, due to the difficulty involved in replacement. The installed bulbs lit up the controls sufficiently, possibly a little less bright than original bulbs, but still very functional. To make the replacement easier, I did the following: 1) Using small file (jeweler's file or nail file/emery board) round all the base boards that the LEDs are mounted on. Hold the LED to keep from rotating while filing, OK to lose a little skin on fingers. 2) Test each light with a battery (6v lantern, probably anything 4V and over would work) and mark the positive side. 3) On opened up car panel with original bulbs removed, use a two pronged loop-back tool (make your own) with a volt meter to measure +12v side of bulb retainer board. 4) Tape new bulb to end of short screwdriver. 5) Align positive side of LED lamp to +12V side of bulb retainer board, use good amount of force to push in and turn. Additional Notes: All six of my bulbs tested good. I measured 900 ohms resistance to the bulb, so current is about 10mA each, should not overheat. Added photo of LED lamp installed in left side of panel, and crude loop-back measurement tool I made with awg 14 house wire and bamboo skewer.

Not bright has expected used it in the ac buttons hardly noticeable...

The large led panel will not fit in the climate control light panel of 2nd hen tacoma

Replaced all the instrument panel bulbs with these, Definitely a awesome upgrade!

I ordered white LEDs and was sent blue ones. Not even going to bother returning them since they're small and cheap. I'd rather just buy new white ones. They have a decent brightness but now my Jeep TJ looks a bit odd until I can get some white ones. Be careful installing them because the plastic is pretty malleable and you have a good chance of warping it with a flathead. Use needle-nose pliers instead.

Perfect fit and looks good. I replaced the white lights in my boat instrument panel and these were just the ticket. However: The circuit board for the LED is larger than the socket and for tight clearance applications theses will be difficult to mount and remove. These DO fit a 2011 Corolla climate control panel but the LED circuit board requires it to be forcefully mounted which can be a little difficult in tight spots. And if you have to remove it to change the polarity chances are you will not get it out in one piece. I didn't cause the board got caught in the tight hole and ripped out. you may want to check polarity first. Or maybe take a Dremmel and trim down the led board a little.

Couldn't turn with the horrible slot in the lights