Wire Connectors, 12 Pack Low Voltage Wire H tap 2 Way connectors 2 Pin solderless with no Wire-Stripping Required for Mid-Span Branching in Wires Connection 20/22 AWG Cable 0.2-0.5mm², by brightfour

Very easy to use

Pulling bulky connectors and plugs through tight motorcycle frame, fairing and handlebar spaces can be tricky. These little reusable connectors allow you to run your bare wires through those tight spaces and back out again with very little hassle. They're secure and seem to hold up to vibration well. I have been using them for LED indicators primarily. I wrap them in loom tape to prevent any rattling against hard surfaces. Very useful.

Only works well with bell wire, so not suitable for garden lights wire.

Small wire connectors, worked well as an easy/inexpensive fix for an issue I had.I had an outdoor decoration that was relatively expensive, and at some point when I have closed the outdoor electric box that the decoration plugs into the small thin wire cable running to the decoration got caught in the box lid and damaged. I was able to use these to cut and reconnect the wire, the decoration works fine now.The connectors I don't believe are waterproof luckily for me the connector is close enough to the plug that I can put it into my weatherproof box.

Too flimsy and fiddly

I have used these type of connectors before they are much neater than the spade and bullet types of connectors. Theses are smaller and neater than others I’ve used in the past. The only downfall with them is if you like me and have no feeling and very little grip they can be fiddly. You have no messy little wire tubes to pick up and throw away as there is no wire stripping involved. Just open the little clear door push your wire in the 2 holes, close the door and your finished. If your not very strong to do it with your fingers just use a pair of pliers and everything will lock into place. To test pull wires and they will be trapped in the connector. Now that you can get a t version at well it means it’s easier to add Spurs and look much better than the 3m connector. They are well worth the money.

I am very very happy I got them. They are very easy to use . No cuts or soldering. Just put cables inside follow instruction on clip and thats it and look very solid and professional 👍👍👍👍👍

A little fiddly especially when trying to connect wires above your head but ultimately do the job. Tip if the wires your using have already have the insulation shaved off at the end cut that bit of wire off as i found it didn’t connect properly (probably just pushed the wire up)